Home > Products > Steel Tubes > Boiler Tubes >

ASTM A333 Grade11 Seamless Steel Pipe for Low Temperature

ASTM A333 Grade11 Seamless Steel Pipe for Low Temperature

ASTM A333 Grade11 Seamless Steel Pipe for Low Temperature
CategoriesBoiler Tubes
AlbumView larger image
Brandfushun
ModelGrade 11
Heat Treatment RequirementsNormalizing or Quenched and Tempered
Surface treatmentOil-dip, Varnish, Passivation, Phosphating, Shot Blasting
Outside Diameter40-400mm
FOB portShanghai
Terms of PaymentL/C, T/T
Update Time2019-09-23
Detail Information

Quality Standard:

ASTM A333 Standard Specification for Seamless and Welded Steel Pipe for Low Temperature Service

Chemical Copmosition(%):

Grade

C

Mn

Si

P

S

Cr

Ni

Mo

Co

Grade 11

0.10 max

0.60 max

0.35 max

0.025 max

0.025 max

0.50 max

35.0-37.0

0.50 max

0.50 max

Size Range

1.Outer Dimensions: 19.05mm-457mm

2.Wall Thickness:2.0mm-60mm

3.Lengths: Lengths required shall be specified on order.If no definite lengths required, following practice applies:

Single Random — 17′ ~ 24′ lengths

Double Random — 36′ ~ 44′ lengths

Heat Treatment Requirements: 

All seamless and welded pipe shall be treated to control their microstructure by the following methods:

1.Normalizing per ASTM A333 Standard Specification for Seamless and Welded Steel Pipe for Low Temperature Service section 4.2.1.1; section 4.2.1.2 or section 4.2.1.3

2.Quenched and Tempered per A 333/A 333M – 05 section 4.2.2.1

3.Double Normalized and Tempered per A 333/A 333M – 05 section 4.2.2.2

Inspection and Test:

Chemical Composition Inspection, Mechanical Properties Test(Tensile Strength,Yield Strength, Elongation, Flaring, Flattening, Bending, Hardness, Impact Test), Surface and Dimension Test,No-destructive Test, Hydrostatic Test.

1.For material heat treated in a batch-type furnace, tests shall be made on 5% of the pipe from each treated lot.

2.For small lots, at least one pipe shall be tested.

3.For material heat treated by the continuous process, tests shall be made on a sufficient number of pipe to constitute 5% of the lot, but in no case less than 2 pipe.

4.Hydrostatic Test

5. Impact Test One notched bar impact test, consisting of breaking three specimens shall be made from each heat represtented in a heat-treatment load on specimens taken from the finished pipe.

Please send your message to us
*Email
Tel
*Title
*Content

Agree to use terms of service

CONTACT PERSON
Florence Tang
leave a message:
Contact Now
Address:
ADD: Room 2014, 20th Floor, Building C1, CIFI International Plaza, No. 222 of Laodong East Road, Changsha, Hunan, China
NEWSLETTER

sign up for the latest catalogue, new design and promotion

follow us